Page 1 of 1

Developing Kodak Technical Pan

Posted: Sun May 05, 2019 1:34 pm
by jsngenda
I've acquired a bulk roll of Kodak tech pan and was wondering if anyone in the forum has any experiencing developing it without the specific kodak developer-- I've picked up some microphen based on the recommendations from the unblinking eye (https://unblinkingeye.com/Articles/Time ... chpan.html) that I'm going to try and use, but if anyone has any advice to offer, I'd appreciate it.

Re: Developing Kodak Technical Pan

Posted: Tue May 07, 2019 6:49 am
by Digitaltruth
Dev times are in the obsolete section of The Massive Dev Chart here:

https://www.digitaltruth.com/devchart.p ... arch&obs=Y

You can access old data in the chart by using either the Advanced Search, or you via the Discontinued/Unlisted page here:

https://www.digitaltruth.com/devchart.p ... scontinued

Re: Developing Kodak Technical Pan

Posted: Tue May 26, 2020 9:42 am
by pentaxpete
I was given a load of the 35mm and 120 rolls but only recently got round to using it. I tested the 35mm first as a short length and used my 'Very Old Dark Brown RODINAL' 1+30 for 10 mins @ 20oC and got good negs -- I COULD have rated film at 40 ASA even instead of 25, So I loaded a 120 roll in my 1984 Mamiya C220 and tested it with the same processing and got amazing resolution ! Be Careful though -- MY RODINAL; was NOT 'Fresh' so if you use 'FRESH' it may be too strong at 1+30 with agitation only once per minute.
https://www.flickr.com/photos/25850987@N03/page2