Changing temperature registered in chart

Film Photography & Darkroom discussion

Moderator: Keith Tapscott.

Post Reply
lil_banana
Posts: 1
Joined: Mon Jun 18, 2018 8:46 pm

Changing temperature registered in chart

Post by lil_banana » Mon Jun 18, 2018 8:56 pm

Hi everyone, I'm going to develop an Ultrafine 400 film with D-76 developer and I discovered the room temperature of water in my city is about 25°C, is there any mathematical formula for the developing times if I want to work with this temperature or should I stick to the chart and use strictly 20°C water for 13 minutes?
Another question I have is about the ratio of developer used, it says 1+1 but I have a little amount of it and I plan not to spend it all in only one develop, Is there any way I can change the ratio to 1+3 or higher?
Sorry for the bad english


Digitaltruth
Site Admin
Posts: 277
Joined: Mon Aug 16, 2004 8:24 pm
Contact:

Re: Changing temperature registered in chart

Post by Digitaltruth » Tue Jun 19, 2018 6:56 am

The online time/temp calculator is here:

https://www.digitaltruth.com/devchart.php?doc=timetemp
Digitaltruth Photo
https://www.digitaltruth.com

Post Reply