Hi all -
I'm setting up a 'temporary' darkroom, which I hope will evolve into a 'long-term' use darkroom, which I hope will be a stepping stone to a permamnent facility.
It will be on one side of a partially finished four-car garage. Ventilation and electrical are already in place; plumbing isn't. I've worked out a satisfactory solution for plumbing as far as getting water into the darkroom goes; my problem is getting waste water out.
The floor is concrete and there is a 'sort-of' drain in place. It's basically a hole in the floor, filled with soil. I'm not to keen on using this as a drain as it is, nor am I keen on the cost of setting up a full scale drainage system.
Short of using one or more large buckets, I'm not coming up with anything. I figure the vast majority of waste water will come from film/print washing and general darkroom clean-up. Film and prints can be washed elsewhere, so most of the waste water to be drained will likely come from simple clean-up when a printing session finished.
However, having a drainage or capture/storage/disposal system in place in the preferred option. I'm open to any suggestions.
Film Photography & Darkroom discussion
Moderator: Keith Tapscott.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests